[osCmax v2.5x] Infobox heading

[gnltech]

Hello all,

Am testing the new v2.5 and I have a question regarding:

Infobox heading

How do you change the rounded grey background image on the infobox heading? I noted there was top_header, top_right , top_left png images?

Can this be done by using one(rounded) image rather than 3 joined images?
any ideas

Testing shop
GNL Tech :

Regards
gnltech

[Shortbus]

That infobox is built from a 3-column table. This allows you to make the infobox wider or narrower by increasing or decreasing the width of the center column of the table. The left and right columns stay the same width so that the corner images will not get distorted. They will always have the same radius.

Perhaps you can change this with the BTS, but I haven't gotten to that part of oscmax yet. Is there a specific reason you want to use one image rather than the three?

[ridexbuilder]

[Where no rounded corners are required, it's possible to clear both left and right <td>s and just use the centre one.]

http://wiki.oscdox.com/v2.5/install_a_new_template

Kudos to the newbie for:
"templates/gnltech/stylesheet.css"

[gnltech]

@Shortbus, I wanted to have one background image since changing those small grey png images is distorting them.

@Ridexbuilder, thanks for the link

[pgmarshall]

Also - inside each of the infoboxes - catalog/includes/boxes/ - you will find at the top of each file a setting for each corner to be rounded or square.

If you know the width of your columns then you can just edit the boxes.tpl.php file in your template folder to be what ever you want ...

Regards,